Reassembled single-phase permanent + IGA
Combined protection device against permanent overvoltages, caused by increases in the network voltage, in single-phase installations, with automatic reconnection. It can also protect against voltage drops if this option is selected by the user by means of a front selector.
Ideal for the protection of electric vehicle charging circuits thanks to the fact that it allows the meter to be reconnected in the event of a power cut when the contracted power is exceeded. The meter must appreciate an infinite impedance that allows it to be reset from the home.
The equipment also has a switched contact output for remote fault indication. It also has a remote control input (run command) which, if not activated, the equipment does not work, it does not make the automatic reconnection. This allows us to cut the supply remotely, for example in case of non-payment of the charge quota or to activate the recharge point with the presence of the vehicle (loop detector or ultrasonic sensor).
Formed by IGA + Trigger/reset coil.
This equipment DOES NOT PROTECT>/strong> against voltage surges TRANSITORY.
|Working tension||240 VAC|
|Power consumption||0,3 VA|
|Maximum section in terminals||25 mm²|
|Environmental margins||-20º…+70º C / 80% H.R.|
|DIN modules number||4|
|Shooting voltage||270 VAC ±2%|
|Response time||according to standard UNE-EN 50550|
|Undervoltage response time||10s|
|Nominal intensity||16, 20, 25, 40, 50, 63A|
|Cutting power||10 kA|
Codes and references
COMBI-PRO 2P16 – POP 1P+N 240Vac + IGA/MCB 2x16A
COMBI-PRO 2P20 – POP 1P+N 240Vac + IGA/MCB 2x20A
COMBI-PRO 2P25 – POP 1P+N 240Vac + IGA/MCB 2x25A
COMBI-PRO 2P32 – POP 1P+N 240Vac + IGA/MCB 2x32A
COMBI-PRO 2P40 – POP 1P+N 240Vac + IGA/MCB 2x40A
COMBI-PRO 2P50 – POP 1P+N 240Vac + IGA/MCB 2x50A
COMBI-PRO 2P63 – POP 1P+N 240Vac + IGA/MCB 2x63A